Hyundai Equus: Overhead Console Lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the overhead console lamp (A) after loosening the overhead console lamp screw(2EA).
|
| 3. |
Disconnect the sunroof switch connector (A) and lamp connector (B).
|
| Installation |
| 1. |
Connect the sunroof switch connector and lamp connector. |
| 2. |
Install the overhead console lamp. |
Room Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver.
3.
Remove the room lamp (A) after removin ...
Hazard Lamp Switch Repair procedures
Inspection
1.
Check "IPM" input/output specification of hazard lamp switch
using the GDS. If the specification is abnormal, replace the hazard
switch module.
2.
Select option "Input/output ...
See also:
Engine Start/Stop Button position
OFF
To turn off the engine, press the Engine Start/Stop Button with the Engine Start/Stop
Button in the ON position and the shift lever in P(Park). When you press the Engine
Start/Stop Button wit ...
Repair procedures
Replacement
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
...
Mode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the
mode control actuator based on the signal of the A/C control unit. ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com