>
Hyundai Equus: Receiver-Drier Repair procedures
| Replacement |
| 1. |
Remove the condenser. |
| 2. |
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
|
| 3. |
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged bottom cap filter.
|
| 4. |
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap. |
| 5. |
Insert a new desiccant into the receiver drier tank. The desiccant must be sealed in vacuum before it is exposed to air for use. |
| 6. |
Install a new bottom cap to the condenser.
|
Condenser Repair procedures
A/C Pressure Transducer Description and OperationOutput Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
...
Heater & A/C Control Unit Components and Components Location
Component
Connector Pin Function
Pin No.Connector A Function1Ground2Rheostat (Illumination -)3Rear Defog Switch4-5Detent Out (+)6HTD 7Illumination + (Tail)8-9Ground10-11Climate CAN High12 ...
Checking the coolant level
WARNING Removing radiator cap
Never attempt to remove the radiator cap while the engine is operating
or hot. Doing so might lead to cooling system and engine damage and could result
in ser ...