Hyundai Equus: A/C Pressure Transducer Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Description and Operation
| Description |
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the cooling fan by
operating it high speed or low speed. Engine ECU stops the operation of
the compressor when the temperature of refrigerant line is very high or
very low irregularly to optimize air conditioning system.
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
Tightening torque :
2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft)
...
A/C Pressure Transducer Repair procedures
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.
2.
Inspect the voltage value whether it is sufficient to be regular v ...
See also:
Fuel Pump Control Module (FPCM) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
...
Fuel Pressure Control Valve Specifications
Specification
ItemSpecificationCoil Resistance (x)0.47 ~ 0.51 [20°C(68°F)]
...
Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com