Hyundai Equus: Accelerator Position Sensor (APS) Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures
| Inspection |
| 1. |
Connect a scantool on the Data Link Connector (DLC). |
| 2. |
Turn the ignition switch ON. |
| 3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram
...
Rail Pressure Sensor (RPS) Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in ...
See also:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may c ...
System operation
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed contro ...
EPB Switch Repair procedures
Removal
1.
Turn ignition switch off and disconnect the battery (-) cable from the battery
2.
Remove the driver side crash pad side cover.
(Refer to Body - "Crash Pad")
3.
Remove the cra ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com