Hyundai Equus: Rail Pressure Sensor (RPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
| Description |
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect a scantool on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refe ...
Rail Pressure Sensor (RPS) Specifications
Specification
...
See also:
Limousine Side Body
Side body A
Front side member tooling hole (O8)Fender apron panel tooling hole (O7)Front door hinge upper mounting hole (O13)Front door hinge lower mounting hole (O13) Fender mounting hole (O6.6 ...
TPMS Receiver Repair procedures
Replacement
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
2)
It will not have any sensor ID's memorized.
It ...
Passenger Airbag (PAB) Module Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disc ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com