>
Hyundai Equus Manuals

Hyundai Equus: A/C Pressure Transducer Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: A/C Pressure Transducer Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Repair procedures

Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.

2.
Inspect the voltage value whether it is sufficient to be regular value or not.

Voltage = 0.00878835 * Pressure + 0.37081095
3.
If the measured voltage value is not wihtin specification, replace the A/C pressure transducer.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).
Tightening torque :
10 ~ 12 N.m (1.02 ~ 1.22 kgf.m, 7.4 ~ 8.8 lb-ft)

   
Be careful not to bend the liquid & suction pipe.
Support the hex portion of the pipe with a wrench while removing or installing the A/C pressure transducer.
5.
Install in the reverse order of removal.
   
When installing, replace it with a new O-ring (A).

    A/C Pressure Transducer Description and Operation
    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the coolin ...

    Evaporator Temperature Sensor Description and Operation
    Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. ...

    See also:

    Immobilizer system
    The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine’s fuel system is disabled. When the Engine Start/Stop Button is in the ON ...

    Do not let your parking brake freeze
    Under some conditions your parking brake can freeze in the engaged position. This is most likely to happen when there is an accumulation of snow or ice around or near the rear brakes or if the bra ...

    27 Brake Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com