>

Hyundai Equus: Rear combination lamp Repair procedures - Lighting System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear combination lamp Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loose the nuts holding the rear combination lamp (outside) then disconnect the connector (A).

3.
Remove the rear combination lamp assembly (A).

4.
Replace the rear combination lamp assembly if the LED get out of order.

    Head Lamps Repair procedures
    Inspection Head Lamp Relay Inspection 1. Pull out the head lamp relay (Low) (A) from the engine compartment relay box. A : Head lamp(Low) relay 2. Check for continuity between terminals. The ...

    Room Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver. 3. Remove the room lamp (A) after removin ...

    See also:

    Standard programming
    To train most devices, follow these instructions: 1. For first-time programming, press and hold the two outside buttons, HomeLink® Channel 1 and Channel 3 Buttons, until the indicator light begins ...

    Battery recharging by vehicle
    After a jump start from a good battery, run the engine for 20-30 minutes at idle or driving the vehicle before it is shutoff. Vehicle may not restart if you shut it off before the battery had chan ...

    Fuel Tank Pressure Sensor (FTPS) Description and Operation
    Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com