>
Hyundai Equus: Stabilizer Bar Repair procedures
| Removal |
| [Front Stabilizer Bar] |
| 1. |
Removal the front wheel & tire.
|
| 2. |
Disconnect the stabilizer link (A) from the front strut assembly by loosening the nut.
|
| 3. |
Disconnect the stabilizer bar (A) from the front sub frame by loosening the bolt.
|
| 4. |
Installation is the reverse of removal. |
| [Rear Stabilizer Bar] |
| 1. |
Remove the rear wheel & tire.
|
| 2. |
Disconnect the rear stabilizer link (A) from the rear lower arm by loosening the nut.
|
| 3. |
Loosen the mounting bolt and then remove the stabilizer bar (A).
|
| 4. |
Installation is the reverse of removal. |
| Inspection |
| 1. |
Check the bushing for wear and deterioration. |
| 2. |
Check the ball joint for rotating torque. |
Lower Arm Repair procedures
Upper Arm Repair proceduresRear Wheel House Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pr ...
Components and Components Location
Components (1)
[5:5 Seat]
1. Rear seat back cover2. Rear seat cushion cover 3. Rear cushion sponge4. Rear seat cushion dfroster5. Rear seat cushion6. Rear seat headrest guide [RH]7. Rear seat ...
6 Speed Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...