>
Hyundai Equus Manuals

Hyundai Equus: Seat Heater Switch Repair procedures - Seat Electrical - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Seat Heater Switch Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Repair procedures

Removal
First Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Remove the seat heater switch assembly (A) after disconnecting the connector and loosening the screws.

Second Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the armrest from the second seat.
(Refer to Body - "Rear Seat Assembly")
3.
Using the remover, remove the armrest upper cover (A).

   
Be careful not to damage the fixed clip of the armrest upper cover.
4.
Remove the switch (A) from the armrest upper cover.

    Air Lumber Support Switch Repair procedures
    Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the shield outer cover. (Refer to Body - "Front Seat Shield Outer Cover") 3. Disconnect the power seat air lumber supp ...

    Electronic Active Headrest Description and Operation
    Description The electronic active headrest is designed to trigger the headrest forward and upward when impact sensor detects a rear (or front) impact. This helps to prevent the driver's and fr ...

    See also:

    Temperature Control Actuator Description and Operation
    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the ...

    Description and Operation
    Description EHPS uses an electromotor to assist you in steering the vehicle. It senses the vehicle speed and road condition.If the engine is off or if the power steering system becomes inoperat ...

    Knock Sensor (KS) Description and Operation
    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com