>

Hyundai Equus: Air Lumber Support Switch Repair procedures - Seat Electrical - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Air Lumber Support Switch Repair procedures

Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover")

3.
Disconnect the power seat air lumber support switch connector (A).

4.
With the power seat air lumber support switch in each position, make sure that continuity exists between the terminal below.
If continuity is not as specified, replace the switch.

Position &
Switch Name
Inflate Cell
Deflate Cell
1
Upper
Upper & middle
Lower
2
Middle
Upper & middle & lower
-
3
Lower
Middle & lower
Upper
4
Deflate
-
Upper & middle & lower

Air Lumber Support
1.
Disconnect the negative(-) battery terminal.
2.
Remove the seat back cover.
(Refer to Body - "Front Seat Back Cover")
3.
Disconnect the air lumber tripple valve unit connector.

Connector
Pin No.
Pin Name
Remarks
Pump motor
1
Pump motor power +
Unit output pin
2
Pump motor GND -
Unit GND pin
Unit
1
Power (B+)
x
2
IGN2
x
3
-
x
4
Deflate switch
x
5
Upper switch
x
6
Middle switch
x
7
Lower switch
x
8
GND
x

4.
With supplying the voltage to the air pump in each position, check that the air lumber support is operated properly.

A.
Upper air pack
B.
Middle air pack
C.
Lower air pack

    Power Seat Motor Repair procedures
    Inspection Slide Motor Limit Switch 1. Disconnect the limit switch (A) and operate the limit switch. 2. Check for continuity between the terminals. 3. Make sure that the seat operation is ...

    Seat Heater Switch Repair procedures
    Removal First Seat 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the seat heater switch a ...

    See also:

    Manifold Absolute Pressure Sensor (MAPS) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Tur ...

    GAWR (Gross axle weight rating)
    This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAW ...

    Headlight, position light, turn signal light, side marker light and front fog light bulb replacement
    (1) Position light (2) Headlight (High) (3) Headlight (Low) (4) Front side marker light (5) Front turn signal light (6) Front fog light 1. Open the hood. 2. Disconnect the negative battery ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com