>

Hyundai Equus: Crash Pad Lower Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Crash Pad Lower Panel Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

2.
After loosening the mounting screws, then remove the crash pad lower panel (A).

3.
Disconnect the crash pad lower panel switch connector (A) and knee airbag (KAB) module connector (B).

4.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Crash Pad Lower Panel Components and Components Location
    Component Location 1. Crash pad lower panel ...

    Glove Box Housing Components and Components Location
    Component Location 1. Glove box housing ...

    See also:

    Components and Components Location
    Components Location 1. Rear shock absorber2. Rear upper arm3. Rear trailing arm4. Rear Assist arm5. Rear sub frame6. Rear disk7. Rear front upper arm ...

    Front Air Strut Assembly Troubleshooting
    Variable damper (CDC) failure criterion ConditionsPhenomenaMaintenance considerationsMechanical conditionsLeaking oilAn oil leak indicates that the part has failed and must be replaced.Inner seam ...

    This device complies with Part 15 of the FCC Rules.
    Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may c ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com