>
Hyundai Equus Manuals

Hyundai Equus: Electronic Active Headrest Repair procedures - Seat Electrical - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Electronic Active Headrest Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Seat Electrical / Electronic Active Headrest Repair procedures

Inspection
1.
How to reassemble the Headrest which was released by rear (or front) Impact.

2.
How to unlock the trigger in case of trigger is locked.
(1)
Normally, the trigger position is unlocking.
(2)
If the position of Trigger is changed by outside impact or by hand, the trigger can’t return to the unlocking position.
(3)
For the change of the trigger position (locking > unlocking), Input the 12V. at connector (A) and push the trigger.

3.
How to check whether installation is completed between the headrest and wiring connector.
(1)
Check for continuity and measure the resistance between No.20 and NO.22 terminals (A).
(In the stafe of headrest Installation)

Standard value : 2.4x ~ 2.8x
(2)
If measured resistance between No.20 and NO.22 terminals is in standard value, please check the below items.
A.
Measure the resistance of connector (A).

Standard value : 2.2x ~ 2.6x
B.
Check for continuity between the wiring and module connector after removing the back panel of seat.
C.
Check for continuity between the module and headrest connector after removing the back panel of seat.

4.
Check the headrest module motor after removing the seat back cover.
(Refer to electrical seat - "Power seat motor"
5.
Check that the impact sensor (A) and wiring is normal after removing the floor console.

    Electronic Active Headrest Schematic Diagrams
    Circuit Diagram ...

    Climate Seat Unit Components and Components Location
    Components 1. Climate control blower2. Climate control ECU3. Climate control TED4. Climate control blower & TED5. Climate seat ECU (Rear seat) ...

    See also:

    Seats
    ...

    SRS Control Module (SRSCM) Repair procedures
    Removal 1. Turn the engine OFF. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console assembly. (Refer to Body - ...

    Rheostat Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lower crash panel and then disconnect the rheostat connector. 3. Check for intensity of new rheostat switch. If th ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com