Hyundai Equus: Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / General Information / Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / General Information / Repair procedures
| Component Replacement after Deployment |
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs. |
When the front airbag(s) deployed after a collision, replace the following items.
| - |
SRSCM |
| - |
Deployed airbag(s) |
| - |
Seat belt pretensioner(s) |
| - |
Front impact sensors |
| - |
SRS wiring harnesses |
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the following items.
| - |
SRSCM |
| - |
Deployed airbag(s) |
| - |
Side impact sensor(s) for the deployed side(s) |
| - |
SRS wiring harnesses
|
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
| - |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM
ignition input, the SRSCM activates the warning lamp for a LED lamp
c ...
Components and Components Location
Components
1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring4. Seat Belt Pretensioner (BPT)5. Front Side Impact Sensor (FSIS)6. Side Airbag (SAB)7. Passenger Airbag (PAB)8. Front Impact Sens ...
See also:
Lane departure warning system (LDWS) (If equipped)
This system detects the lane with the sensor at the front windshield and warns
you when your vehicle leaves the lane.
WARNING
The LDWS does not make the vehicle change lanes. It is the driver ...
Front Wheel Speed Sensor Components and Components Location
Components
1. Front wheel speed sensor cable2. Front wheel speed sensor
...
ESP Control Unit Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable
2.
Remove the Engine room junction box after removing the cover.
3.
Disconnect the brake tubes from the HE ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com