Hyundai Equus: Repair procedures
| Diagnosis With GDS |
| 1. |
BSD system defects can be quickly diagnosed with the GDS. GDS
operates actuator quickly to monitor, input/output value and self
diagnosis. |
| 2. |
Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS. |
| 3. |
Select the vehicle model and then BSD system. |
| 4. |
Select "Current Data", if you want to check current data of BSD system.
|
| 5. |
If you want to check each module operation forcefully, select "Actuation test".
|
Description and Operation
Description
The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
- ...
Blind Spot Detection Unit Schematic Diagrams
Circuit Diagram
...
See also:
Middle Speed Sensor Description and Operation
Description
The middle speed sensor measures the rate of rotation of the
6C outer drum inside the transmission and delivers the readings to the
TCM. ...
Hood Seal Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the hood seal weatherstrip (A).
•
Be careful not to scratch the hood seal weatherstrip.
2.
Installation is the rev ...
Troubleshooting
Troubleshooting
1.
After replacing multi-view camera unit, always check that the system operates properly.
2.
If the failure persists after replacing the multi-view camer ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com