>
Hyundai Equus: Changing a tire with TPMS
If you have a flat tire, the Low Tire Pressure and Position telltales will come on. Have the flat tire repaired by an authorized EQUUS dealer as soon as possible or replace the flat tire with the spare tire.
CAUTION
Never use a puncture-repairing agent not approved by EQUUS dealer to repair and/or inflate a low pressure tire. Tire sealant not approved by EQUUS dealer may damage the tire pressure sensor.
Each wheel is equipped with a tire pressure sensor mounted inside the tire behind the valve stem. You must use TPMS specific wheels. It is recommended that you always have your tires serviced by an authorized EQUUS dealer.
If you drive the vehicle for about 10 minutes at speeds above 15 mph (25 km/h) after replacing the low pressure tire with the spare tire, the below will happen:
You may not be able to identify a tire with low pressure by simply looking at it. Always use a good quality tire pressure gauge to measure. Please note that a tire that is hot (from being driven) will have a higher pressure measurement than a tire that is cold.
A cold tire means the vehicle has been sitting for 3 hours and driven for less than 1 mile (1.6 km) in that 3 hour period.
Allow the tire to cool before measuring the inflation pressure. Always be sure the tire is cold before inflating to the recommended pressure.
WARNING - TPMS
WARNING - Protecting TPMS
Tampering with, modifying, or disabling the Tire Pressure Monitoring System (TPMS) components may interfere with the system's ability to warn the driver of low tire pressure conditions and/or TPMS malfunctions. Tampering with, modifying, or disabling the Tire Pressure Monitoring System (TPMS) components may void the warranty for that portion of the vehicle.
TPMS (Tire Pressure Monitoring System) malfunction indicator
This device complies with Part 15 of the FCC rules.Cool and Warm Box Components and Components Location
Component Location
1. Cool & Warm Box Bracket2. Wire Harness3. Front Duct4. Cool & Warm Box Assembly5. Wire Harness6. Cool & Warm Box Partition7. Circuit Board Cover8. Circuit Board9. ...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
...
Components and Components Location
Components
1. Door module2. Window glass3. Power window motor4. Outside handle cover 5. Outside handle6. Door panel7. Door checker8. Door striker9. Outside handle pad10. Door striker cover11. Do ...