>
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Stabilizer Bar Repair procedures
Removal
[Front Stabilizer Bar]
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect the stabilizer link (A) ...
Warning lights
✽ NOTICE - Warning lights
Make sure that all warning lights are OFF after starting the engine. If any
light is still ON, this indicates a situation that needs attention.
Supplemental Restra ...
Side Impact Sensor (SIS) Description and Operation
Description
The Side Impact Sensor (SIS) system consists of two kinds of
side impact sensor which are installed at each center of the front door
module (left and right) and two rear sensors whi ...