Hyundai Equus: Camshaft Position Sensor (CMPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Description and Operation
| Description |
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and
detects the piston position of each cylinder which the CKPS can't
detect.
The CMPS is installed on engine head cover and uses a target
wheel installed on the camshaft. The Cam Position sensor is a
hall-effect type sensor. As the target wheel passes the Hall sensor, the
magnetic field changes in the sensor. The sensor then switches a signal
which creates a square wave.
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) ...
Camshaft Position Sensor (CMPS) Specifications
Specification
ItemSpecificationOutput Voltage (V)High : 5.0VLow : 0.7VAir Gap (mm)0.2 ~ 2.0
...
See also:
ON/OFF Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Rear Driveshaft (VL-VL TYPE) Components and Components Location
Component location
1. Rear driveshaft assembly(R)2. Rear driveshaft assembly(L)
...
Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives
the vehicle identification number (VIN). ...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com