>
Hyundai Equus: Recalling Position into Memory
1. Check that the shift lever is in P (Park) and the Engine Start/Stop Button
is in the ON position.
2. Press the desired memory button (1 or 2). The system will beep once, then the
driver's seat, outside rearview mirrors, steering wheel and HUD (Head-Up Display)
height will automatically adjust to the stored positions.
Pressing one of the control buttons for the driver’s seat, the outside rearview mirrors, or the steering wheel while the system is recalling the stored positions will cause the movement for that component to stop and move in the direction that the control button is pressed. Other components will continue to the recalled position.
WARNING
Use caution when recalling adjustment memory while sitting in the vehicle. Push the seat position control knob to the desired position immediately if the seat moves too far in any direction.
Storing Position into Memory
Easy Access FunctionDescription and Operation
Refrigeration Cycle
...
Steering Wheel Remote Controller (SWRC) Repair procedures
Inspection
1.
Check for resistance between terminals in each switch position.
[LH Top (Audio)]
SwitchConnectorterminalResistance(±5%)Volume Down6-7240 xSeek Down510 xMode940 xVolume Up1.69 kxSe ...
Tire terminology and definitions
Air Pressure:
The amount of air inside the tire pressing outward on the tire. Air pressure
is expressed in pounds per square inch (psi) or kilopascal (kPa).
Accessory Weight:
This means the com ...