>

Hyundai Equus: Radiator Grill Repair procedures - Front Bumper - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Radiator Grill Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Remove the radiator grill center bracket mounting rivet and then loosen the screws.
3.
Remove the radiator grill center bracket (A).

4.
Loosen the radiator grill mounting screws.
5.
Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill (A).

6.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Radiator Grill Components and Components Location
    Component Location 1. Radiator grill ...

    Rear Bumper
    ...

    See also:

    Pre-active Seat Belt (PSB) Repair procedures
    Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the safety belt (A) by turning it in the direction of arrow using a flat ...

    Repair procedures
    Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the front looking sensor to stop functioning. ...

    Crach Pad Center Panel Components and Components Location
    Component Location 1. Crash pad center panel ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com