Hyundai Equus: Special Service Tools
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Driveshaft and axle / General Information / Special Service Tools
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Driveshaft and axle / General Information / Special Service Tools
| Special Service Tools |
| Tool(Number and Name) | Illustration | Use |
| 09581-11000 Piston expander |
| Spreading the front disc brake piston. |
| 09568-2J100 Ball joint remover |
| Removal of the rear assist arm and tie rod end ball joint. |
| 9530-3T100 Bearing outer race installer |
| Installation of theBearing outer race. (Use with 09231-H1100) |
| 09530-3T200 Removing plate |
| Removal of the pinion drive inner bearing. |
| 09530-3T300 Differential assembly warking stand |
| Removal & Installation of the differential assembly warking stand. |
| 09530-3T400 Pinion height gauge (3 piece set) |
| Pinion height measuring gauge. |
| 09530-3T500 Differential side oil seal installer |
| Installation of the differential side oil seal. (Use with 09231-H1100) |
| 09530-3T600 Pinion oil seal installer |
| Installation of the pinion oil seal installer. (Use with 09231-H1100) |
| 09527-4A000 Removing plate |
| Removal of the differential carrier assembly inner bearing. |
| 9453-3B200 Bearing installer |
| Installation of the differential carrier assembly inner bearing. |
| 09532-11500A Bearing outer race installer |
| Installation of the bearing outer race. (Use with 09500-11000) |
| 09231-H1100 Bar |
| Use with 9530-2W100, 09530-2W700, 09431-26200. |
| 09500-11000 Bar |
| Use with 9532-11500A. |
Specifications
Specification
ItemsInner sideOuter sideRear driveshaftJoint typeCross grove(VL)Cross grove(VL)Max. permissible angle21°21°DifferentialOil typeHypoid gear oil MS 517-15 GT(SAE 75W/90, API GL-5, ...
Troubleshooting
Troubleshooting
Trouble SymptomProbable causeRemedyVehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and st ...
See also:
Components and Components Location
Component Location
1. Engine room relay box (Rear glass defogger)2. Rear window defogger switch (A/C controller)3. Rear window defogger4. Body control unit
...
Air Lumber Support Switch Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover")
3.
Disconnect the power seat air lumber supp ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com