Hyundai Equus: Presure Switch Specifications
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Presure Switch Specifications
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Presure Switch Specifications
| Specifications |
| Specifications (20°C(68°F)) | |
| OFF => ON | 146 ± 40 kPa |
| ON => OFF | 50 kPa |
Presure Switch Description and Operation
Description
The oil pressure switch detects any abnormal hydraulic pressure to the 35R clutch in the N range. ...
Presure Switch Schematic Diagrams
Circuit Diagram
...
See also:
Owner’s responsibility
✽ NOTICE
Maintenance Service and Record Retention are the owner's responsibility.
You should retain documents that show proper maintenance has been performed on
your vehicle in accordan ...
Reservoir Tank Repair procedures
Removal
•
Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts.
(Refer to Air Suspension System - "Repair procedures ...
ON/OFF Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com