Hyundai Equus: Presure Switch Schematic Diagrams

Presure Switch Specifications

Specifications Specifications (20°C(68°F))OFF => ON146 ± 40 kPaON => OFF50 kPa ...

Presure Switch Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

See also:

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be use ...

Height Adjust Repair procedures
Replacement 1. Remove the front seat belt upper anchor. (Refer to Front Seat Belt - "Front Seat Belt Pretensioner") 2. After loosening the mounting bolts, then remove the height adjustor (A) ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...