>
Hyundai Equus Manuals

Hyundai Equus: Presure Switch Repair procedures - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Presure Switch Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Presure Switch Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
1.
Draining ATF totally.
(Refer to Hydraulic system - "Fluid")
2.
Disconnector the E-Module connector (A).
(1)
Press the lock.
(2)
Pull up the lever.

3.
Remove the oil pan (A).
Tightening torque : 1.4 ~ 1.6 kgf.m

   
Replace the gasket before reinstalling the oil pan.

4.
Remove the valve body assembly (A).

5.
Disconnect the pressure switch connector (A).

6.
Remove the pressure switch (A).
Tightening torque :
0.4 ~ 0.5 kgf.m (3.9 ~ 4.9 N.m, 2.88 ~ 3.6 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Adding Automatic Transmission Fluid(ATF).
(Refer to Hydraulic System - " Fluid ")
    Presure Switch Schematic Diagrams
    Circuit Diagram ...

    6 Speed Clutch Control Solenoid Valve Description and Operation
    Description 6 Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 6 Clutch. ...

    See also:

    If engine stalls while driving
    1.Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. 2.Turn on your emergency flashers. 3.Try to start the engine again. If your vehicle will not s ...

    General Safety Information and Caution
    Instructions When Handling Refrigerant 1. R-134a liquid refrigerant is highly volatile. A drop on the skin of your hand could result in localized frostbite. When handling the refrigerant, be ...

    Mode Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com