>

Hyundai Equus: Ignition Coil Repair procedures - Ignition System - Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Ignition Coil Repair procedures

Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the LH/RH ignition coil connectors (A).

4.
Remove the LH/RH ignition coil (A).

   
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation
1.
Install in the reverse order of removal.

Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).


Standard value: 0.62x ± 10%

    Ignition Coil Schematic Diagrams
    Circuit Diagram ...

    Spark Plug Description and Operation
    Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture there ...

    See also:

    Headlight, position light, turn signal light, side marker light and front fog light bulb replacement
    (1) Position light (2) Headlight (High) (3) Headlight (Low) (4) Front side marker light (5) Front turn signal light (6) Front fog light 1. Open the hood. 2. Disconnect the negative battery ...

    Repair procedures
    Operation and Leakage Check Check all of the following items ComponentProcedureBrake Booster (A)Check brake operation by applying the brakes during a test drive. If the brakes do not work proper ...

    Troubleshooting
    Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com