>
Hyundai Equus Manuals

Hyundai Equus: Multi Function Switch(MFSW) Description and Operation - Body Network System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Multi Function Switch(MFSW) Description and Operation

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Body Network System / Multi Function Switch(MFSW) Description and Operation

Description
1.
Multi Function Switch (MFSW)

(1)
Main features
Item
Description
Installation location
 Multi Function Switch (right)
Component configuration
1.
ECU
2.
CAN Communication IC: Body Electrical System
3.
MFS (Light & Wiper Switch)
Main features
1.
The wiper and washer switch signals are transmitted via CAN Line
2.
Lamp (Tail Lamp, Head Lamp, Fog Lamp, Auto Light, Turn Signal Lamp) Switch signals are transmitted via CAN
3.
Wiper LOW Backup Line - Wiper Control Module
(for failsafe function in case of communication line failure)
4.
Washer relay operation.
5.
CAN communication with embedded IC (BCM CAN communication module)

(2)
For detail information about circuit diagram, refer to the multifunction switch.
(Refer to "Multifunction Switch")
    Assist Power Seat Module(APSM) Description and Operation
    Description 1. Assist Power Seat Module (APSM) (1) Main features ItemDescriptionInstallation location Lower section of the assist side seatComponent configuration 1. Embedded with CAN Commu ...

    Steering Wheel Remote Controller (SWRC) Description and Operation
    Description 1. Steering Wheel Remote Controller (SWRC) (1) Main features ItemDescriptionInstallation location Located on the driver side handle (CAN Module is embedded in the audio switch on ...

    See also:

    TPMS Receiver Description and Operation
    Description 1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. B. In this state, there is no Auto-Lo ...

    Limousine Front Body
    Front body A Roof panel front cornerFront pillar outer cornerHood hinge mounting hole (O13)Shockabsorber mounting hole (O24)Front end module mounting hole (O9)Cowl top cover mounting hole (O7) F ...

    Reprogramming a single HomeLink® button
    To program a new device to a previously trained HomeLink® button, follow these steps: 1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed. 2. When th ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com