>

Hyundai Equus: Fuel Pressure Sensor (FPS) Description and Operation - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Fuel Pressure Sensor (FPS) Description and Operation

Description
The fuel pressure sensor (FPS) is installed on top of the low pressure fuel pump and measures the pressure of the low pressure fuel line. Based on the current fuel pressure and the amount of fuel consumed, the fuel pump control module (FPCM) determines whether to activate the low pressure fuel pump. After activating the low pressure fuel pump, the FPS continues to communicate with the FPCM to measure the fuel pressure and control the supply of low pressure fuel.
    Fuel Pump Control Module (FPCM) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Specification: Refer to “Specification” ...

    Fuel Pressure Sensor (FPS) Specifications
    Specification Pressure(kPa)Output Voltage(V)500.36002.511004.5 ...

    See also:

    Multimedia system
    ✽ NOTICE If you install an aftermarket HID head lamp, your vehicle’s audio and electronic device may malfunction. Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cle ...

    Center Pillar Trim Components and Components Location
    Component Location 1. Center pillar lower trim2.Center pillar upper trim ...

    Hood Seal Weatherstrip Repair procedures
    Replacement 1. Detach the clips, then remove the hood seal weatherstrip (A).     • Be careful not to scratch the hood seal weatherstrip. 2. Installation is the rev ...

    Categories

    Hyundai Equus Manuals

    2011-2025 Copyright www.heqmanual.com