>
Hyundai Equus Manuals

Hyundai Equus: Assist Power Seat Module(APSM) Description and Operation - Body Network System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Assist Power Seat Module(APSM) Description and Operation

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Body Network System / Assist Power Seat Module(APSM) Description and Operation

Description
1.
Assist Power Seat Module (APSM)

(1)
Main features
Item
Description
Installation location
 Lower section of the assist side seat
Component configuration
1.
Embedded with CAN Communication IC
2.
Embedded with the Relax Operation Confirm Buzzer
Main features
1.
Manual function (manual control through switch operation)
2.
Confirm buzzer sounds (1 time) after relax operation is complete
3.
Control engaged after RR Auto Switch input
4.
Slide, Recline, and RR Slide Limit Switch applied
5.
Seat Back Slide and Recline Walk-In Switch applied
6.
RR Slide Switch Input/Output Control
7.
Engages CAN communication with the Rear Seat Arm Rest Switch
8.
Added limit setting mode using the scanner

(2)
Power seat signal flow

(3)
For detail information about circuit diagram, refer to the power window switch.
(Refer to IMS (Integrated Memory System) - "Memory Power Seat Unit")
    Power Seat Module(PSM) Description and Operation
    Description 1. Power Seat Module (PSM) (1) Main features ItemDescriptionInstallation location Lower section of the driver side seatComponent configuration 1. Embedded with CAN Communication ...

    Multi Function Switch(MFSW) Description and Operation
    Description 1. Multi Function Switch (MFSW) (1) Main features ItemDescriptionInstallation location Multi Function Switch (right)Component configuration 1. ECU 2. CAN Communication IC: B ...

    See also:

    Output Speed Sensor Specifications
    Specifications x Type: Hall effect sensor x Specifications Operation condition (°C)°F((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltageHigh1.4Low0.7 ...

    Starter Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the starter cable (A) from the B terminal on the solenoid, and the connector (B) from the S ter ...

    Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
    Specifications Direct control VFS[UD/C] x Control type : Normal low type Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistance ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com