>

Hyundai Equus: Hood Insulator Pad Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Hood Insulator Pad Repair procedures

Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
   
•
Be careful not to scratch the hood panel.

2.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
    Hood Lift Repair procedures
    Replacement     • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdrive ...

    Hood Seal Weatherstrip Repair procedures
    Replacement 1. Detach the clips, then remove the hood seal weatherstrip (A).     • Be careful not to scratch the hood seal weatherstrip. 2. Installation is the rev ...

    See also:

    Smart Cruise Control Unit Repair procedures
    Removal 1. Remove the bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the smart cruise control unit connector (A). 3. Loosen the nuts (B) and then remove the smar ...

    Front Lower Arm Repair procedures
    Removal Remove the lateral arm. 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • ...

    Lane departure warning system (LDWS) (If equipped)
    This system detects the lane with the sensor at the front windshield and warns you when your vehicle leaves the lane. WARNING The LDWS does not make the vehicle change lanes. It is the driver ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com