>
Hyundai Equus Manuals

Hyundai Equus: Hood Lift Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Hood Lift Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Lift Repair procedures

Replacement
   
•
When removing and installing the hood lifter, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdriver (A), lift the socket clips (B) up slightly on both ends of the lifter and then remove the lifter from the bracket.

2.
Push the socket of the lifter into the bracket for installation.
   
•
Make sure the hood locks/unlocks and opens/closes properly.
    Hood Assembly Repair procedures
    Replacement     • Be careful not to damage the hood and body.     • When removing and installing the hood, an assistant is necessary. • Wh ...

    Hood Insulator Pad Repair procedures
    Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Installation is th ...

    See also:

    PGS Unit (Back & Blinde Unit) Schematic Diagrams
    Circuit Diagram ...

    Blind Spot Detection Switch Components and Components Location
    Component ...

    Fuel Pump Control Module (FPCM) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Specification: Refer to “Specification” ...

    Categories

    Hyundai Equus Manuals

    2011-2025 Copyright www.heqmanual.com