>
Hyundai Equus Manuals

Hyundai Equus: Hood Assembly Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Hood Assembly Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly Repair procedures

Replacement
   
•
Be careful not to damage the hood and body.
   
•
When removing and installing the hood, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).

2.
After loosening the hood hinge (A) mounting bolts, remove the hood assembly (B).
Tightening torque :
21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

3.
Installation is the reverse of removal.
   
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the hood alignment.
    Hood Assembly Components and Components Location
    Component Location 1. Hood assembly ...

    Hood Lift Repair procedures
    Replacement     • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdrive ...

    See also:

    Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Front Wheel Speed Sensor Repair procedures
    Removal 1. Remove the connector after removing the front wheel speed sensor clip. 2. Remove the front wheel speed sensor. (Refer to Driveshaft and Axle - "Front Axle Assembly") 3. Install ...

    Compressor Components and Components Location
    Components 1. Center Bolt2. Hub Bolt3. Hub Assembly4. Snap Ring5. Pulley6. Compressor Assembly ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com