Hyundai Equus: Spliter Unit Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Premium AVN System / Spliter Unit Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Premium AVN System / Spliter Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the floor console.
(Refer to Body - "Floor Console Assembly") |
| 3. |
Remove the spliter unit (A) after disconnecting the connectors and loosening the mounting bolts.
|
| Installation |
| 1. |
Install the spliter unit after connecting connector.
|
| 2. |
Install the floor console. |
| 3. |
Connect the negative (-) battery terminal and then check to operate the rear monitor. |
Spliter Unit Description and Operation
Description
The spliter unit receive the LVDS signal from AVN head unit and send it to left/right rear monitor.
(LVDS : Low Voltage Differential Signaling ) ...
Mic Repair procedures
Removal
1.
Remove the hands free mic (A) from the roof trim.
Installation
1.
Install the hands free mic after connecting the mic connector.
Inspection
1.
Remove the handsfree mic (A) aft ...
See also:
Description and Operation
Memory Power Seat (PSM) Control (For Driver)
Description
The seat operation function in PSM contains the following functions.
1.
Manual control(CAN Signal data from DDM to PDM) with manual switc ...
Smart Cruise Control Switch Repair procedures
Inspection
[Measuring Resistance]
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function ...
Description and Operation
Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine
operating conditions are pre-pro grammed i ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com