Hyundai Equus: VSM OFF Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / ESP(Electronic Stability Program) System / VSM OFF Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / ESP(Electronic Stability Program) System / VSM OFF Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
| 3. |
Remove the TORX screws to remove the fixed bracket.
(Refer to Body Electrical System - "Steering Wheel Remote Controller ") |
VSM OFF Switch Schematic Diagrams
Part Circuit Diagram
...
Steering Angle Sensor Description and Operation
Description
Steering Wheel Angle Sensor detects rotating direction of the
vehicle. Rotating direction detected by the sensor is communicated with
HECU as CAN signal involving information about ...
See also:
Good braking practices
WARNING
Whenever leaving vehicle or parking, always set the parking brake as
far as possible and fully engage the vehicle's transmission into the park position.
Vehicles not fully engage ...
Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition c ...
Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECT ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com