>

Hyundai Equus: Side Impact Sensor (SIS) Description and Operation - SRSCM - Restraint - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Side Impact Sensor (SIS) Description and Operation

Description
The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors which are installed in the rear pillar (left and right).
•
The Front Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
•
The Rear Side Impact Sensor is also called A-SIS because it detects acceleration due to collision at its mounting location.
SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when collision occurrs.
    Front Impact Sensor (FIS) Repair procedures
    Removal     • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor co ...

    Side Impact Sensor (SIS) Components and Components Location
    Components ...

    See also:

    Auto Defogging Sensor Description and Operation
    Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control m ...

    GAWR (Gross axle weight rating)
    This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAW ...

    Checking the power steering fluid level
    With the vehicle on level ground, check the fluid level in the power steering reservoir periodically. The fluid should be between MAX and MIN marks on the side of the gauge at the normal tempe ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com