>
Hyundai Equus Manuals

Hyundai Equus: Front Impact Sensor (FIS) Repair procedures - SRSCM - Restraint - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Impact Sensor (FIS) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the radiator assembly.
(Refer to Engine Mechanical System - "Radiator")
3.
Disconnect the front impact sensor connector (A), and them loosen the nuts to remove the front impact sensor (B).
[Driver's side]

[Passenger's side]

Installation
   
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Install a new front impact sensor.
2.
Tighten the front impact sensor mounting nut.
Tightening torque :
8.0 ~ 10.0 N.m (0.82 ~ 1.02 kgf.m, 5.9 ~ 7.4 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the radiator assembly.
5.
Reconnect the battery negative cable.
6.
After installing the front impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
    Front Impact Sensor (FIS) Components and Components Location
    Components ...

    Side Impact Sensor (SIS) Description and Operation
    Description The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors whi ...

    See also:

    Fuel Pressure Control Valve Troubleshooting
    Signal Waveform ...

    Changing tires
    1.Park on a level surface and apply the parking brake firmly. 2.Shift the shift lever into P (Park). 3.Activate the hazard warning flasher. 4.Remove the wheel lug nut wrench, jack, jack han ...

    Presure Switch Specifications
    Specifications Specifications (20°C(68°F))OFF => ON146 ± 40 kPaON => OFF50 kPa ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com