Hyundai Equus: TPMS Receiver Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Repair procedures
| Replacement |
When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is
used to replace the faulty part i.e. it must be High Line (95800-3N200)
in order to have the correct inflation warning thresholds set. |
| 1. |
Disconnect vehicle battery. |
| 2. |
Remove the crash pad.
(Refer to BD - "Crash Pad") |
| 3. |
Remove faulty part and fit bracket assembly to new part.
|
| 4. |
Secure new part to vehicle and fit connector. |
| 5. |
Re-connect battery and turn Ignition on.
Vehicle Name Writing
VIN Writing
|
TPMS Receiver Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-Lo ...
Steering System
...
See also:
Components and Components Location
Components
1. Glass panel2. Decoration cover3. Drip link4. Guide assembly5. Drip rail6. Sunshade7. Defector8. Defector link 9. Seal tape10. Motor11. Frame12. Set plate
...
ON/OFF Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Electronic Active Headrest Components and Components Location
Component location
1. Active headrest connector2. Elevator system connector3. Impact sensor4. Electronic active headrest
...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com