>
Hyundai Equus Manuals

Hyundai Equus: Solenoid Valve Repair procedures - Air Suspension System - Suspension System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Solenoid Valve Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Suspension System / Air Suspension System / Solenoid Valve Repair procedures

Removal
   
•
Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts.
(Refer to Air Suspension System - "Repair procedures (Air Injection Procedure)")
•
This system combines a sensor and electronic parts with mechanical components, so be careful not to subject the system to strong impacts.
•
If any pins are visible inside the electric signaling connector, do not expose it to water.
•
A plug protects the air inlet of the reservoir tank from dust or other particles. Do not remove the plug except when assembling or disassembling the reservoir tank.
•
DO NOT hold any parts by their electric wires while moving them, as the weight of the part may damage the wire or connection during transport.
•
Do not pile components on top of each other.
•
Do not apply power to operate the compressor directly (may cause malfunctions/overheating).
•
Be careful not to break any circuits by twisting or bending the cables.
•
When installing an air hose, be careful not to kink the hose.
•
DO NOT reuse the air hose connector connected to an air hose assembly after it has been disassembled.
•
The markings on both ends of the air hose distinguishes the assembly, so be careful not to peel it off.
•
DO NOT drop the solenoid valve as it contains a pressure sensor.
1.
Removal the front bumper.
(Refer to Body)
2.
Removal the right head light.
(Refer to Body Electrical System)
3.
Disconnect the connector (A).

4.
Disconnect the air tube.

   
•
Remove the air fally with enough interval of time and separate completely.
5.
Loosen the bolt by then remove the solenoid valve (A).

6.
Installation is the reverse of removal.
    Solenoid Valve Schematic Diagrams
    Circuit diagram 1. Solenoid valve connector terminal 2. Solenoid valve terminal function TerninalFunction1Air spring valve FL2Ambiance valve3Air spring valve RR4Air spring valve RL5Solenoid ...

    Air Filter Components and Components Location
    Components Location 1. Air filter2. Y-Connector3. Mounting bracket ...

    See also:

    Filter replacement
    1. With the glove box open, remove the stoppers on both sides to allow the glove box to hang freely on the hinges. 2. Remove the cylinder at the left of the glove box. 3. Remove the cl ...

    Schematic Diagrams
    Schematic Diagram ...

    If engine doesn't turn over or turns over slowly
    1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. 3. Turn on the interior light. If the ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com