>
1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.
2. Check the battery connections to be sure they are clean and tight.
3. Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.
4. Check the starter connections to be sure they are securely tightened.
5. Do not push or pull the vehicle to start it. See instructions for "Jump starting".
WARNING
If the engine will not start, do not push or pull the car to start it.This could result in a collision or cause other damage.
Instrument Cluster Components and Components Location
Components
Connector Pin Information
No.DescriptionNo.Description1Aig bag +21-2-22Speaker +3Rheostat down switch23Speaker -4Rheostat up switch24-5-25Vehicle speed 4P output6Oil pressure26R Output7 ...
Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, and put a finger on t ...
Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Circuit Diagram
...