>
1. Check that the shift lever is in P (Park) and the Engine Start/Stop Button
is in the ON position.
2. Adjust the driver’s seat, outside rearview mirrors, steering wheel and HUD (Head-Up
Display) height to positions comfortable for the driver.
3. Press the SET button on the control panel. The system will beep once.
4. Press one of the memory buttons (1 or 2) within 5 seconds after pressing the
SET button. The system will beep twice when the positions of the driver's seat,
outside rearview mirrors, steering wheel and HUD (Head-Up Display) height have been
successfully stored.
B Pillar Garnish Repair procedures
Replacement
[B Pillar upper garnish]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protec ...
Electronic Active Headrest Repair procedures
Inspection
1.
How to reassemble the Headrest which was released by rear (or front) Impact.
2.
How to unlock the trigger in case of trigger is locked.
(1)
Normally, the trigger position is un ...
Cleaning the interior window glass
If the interior glass surfaces of the vehicle become fogged (that is, covered
with an oily, greasy or waxy film), they should be cleaned with glass cleaner. Follow
the directions on the glass clea ...