Hyundai Equus: 27 Brake Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 27 Brake Control Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 27 Brake Control Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
27 Brake Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description and Operation
Description
UD Clutch control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic
pressure inside the UD Clutch. ...
See also:
Brake Booster Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests.
1.
Run the engine for one or two minutes, and then stop it. If
the pedal depress ...
Upper Arm Repair procedures
Removal
[Front Upper arm]
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Removal the air strut assembly.
(Refer ...
Inner panel fuse replacement
1. Turn the ignition switch and all other switches off.
2. Open the fuse panel cover.
3. Pull the suspected fuse straight out. Use the removal tool provided in the
driver’s side panel or the ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com