>

Hyundai Equus: Inner panel fuse replacement - Fuses - Maintenance - Hyundai Equus 2009-2022 Owners ManualHyundai Equus: Inner panel fuse replacement

1. Turn the ignition switch and all other switches off.


1. Turn the ignition switch and all other switches off.
2. Open the fuse panel cover.

3. Pull the suspected fuse straight out. Use the removal tool provided in the


3. Pull the suspected fuse straight out. Use the removal tool provided in the drivers side panel or the front passengers side panel.

4. Check the removed fuse; replace it if it is blown.

Spare fuses are provided in the passenger compartment panel fuse panels (or in the engine compartment fuse panel).

5. Push in a new fuse of the same rating, and make sure it fits tightly in the clips.

If it fits loosely, consult an authorized EQUUS dealer.

If you do not have a spare, use a fuse of the same rating from a circuit you may not need for operating the vehicle, such as the cigarette lighter fuse.

If the headlights or other electrical components do not work and the fuses are OK, check the fuse panel in the engine compartment. If a fuse is blown, it must be replaced.

Fuse switch

Always put the transportation fuse switch at the ON position.


Always put the transportation fuse switch at the ON position.

If you move the switch to the OFF position, some items such as the audio and digital clock must be reset and the smart key may not work properly.

CAUTION

  • Always place the transportation fuse switch in the ON position while driving the vehicle.
  • Do not move the transportation fuse switch repeatedly. The fuse switch may be worn out.

✽ NOTICE

If you need to park your vehicle for prolonged periods more than 1 month, move the transportation fuse switch to the OFF position to prevent the battery being discharged.

    Fuses
    A vehicles electrical system is protected from electrical overload damage by fuses. This vehicle has 4 fuse panels, two located in the drivers side and passengers side panel bolster, the oth ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

    See also:

    Camshaft Position Sensor (CMPS) Repair procedures
    Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to Wave Form Removal     DONT remove the camshaft position se ...

    Cowl Cross Bar Assembly Components and Components Location
    Component Location 1. Cowl cross bar assembly ...

    Rear Wheel Speed Sensor Repair procedures
    Removal 1. Remove the rear wheel speed sensor mounting bolt. Tightening torque: 6.9 ~ 10.8 Nm (0.7 ~ 1.1 kgf.m, 5.1~ 8.0 lb-ft) 2. Remove the rear wheel guard. 3. Disconnect the rea ...

    Categories

    Hyundai Equus Manuals


    2011-2022 Copyright www.heqmanual.com