Hyundai Equus: 4&OD Clutch Control Solenoid Valve Schematic Diagrams

4&OD Clutch Control Solenoid Valve Specifications

Specifications Direct control VFS[4&OD/C] x Control type : Normal high type Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistanc ...

4&OD Clutch Control Solenoid Valve Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

See also:

Repair procedures
Compression Pressure Inspection     If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up engine to norma ...

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may c ...

Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tightening torque : 2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft) ...