Hyundai Equus: Presure Switch Schematic Diagrams

Presure Switch Specifications

Specifications Specifications (20°C(68°F))OFF => ON146 ± 40 kPaON => OFF50 kPa ...

Presure Switch Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

See also:

MTS Antenna Repair procedures
Removal 1. Remove the roof antenna. (Refer to Audio - "Antenna") (Refer to AVN System - "Roof Antenna") Installation 1. Install the roof antenna. (Refer to Audio - "Antenna") (Refer to AV ...

Knock Sensor (KS) Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System� in EM group). 3. Disconnect ...

Thermostat Repair procedures
Removal and Installation 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 4.0~6.0N.m (0.4~0.6kgf.m, 3.0~4.4lb-ft) 2. Remove the air duct, air intak hose and ...