Intake Air Temperature Sensor (IATS) is included inside
Manifold Absolute Pressure Sensor and detects the intake air
temperature.
To calculate precise air quantity, correction of the air
temperature is needed because air density varies according to the
temperature. So the ECM uses not only MAPS signal but also IATS signal.
This sensor has a Negative Temperature Coefficient (NTC) Thermister and
it's resistance changes in reverse proportion to the temperature.
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Tur ...
Specification
TemperatureResistance (kx)°C°F-40-4040.93 ~ 48.35-20-413.89 ~ 16.030325.38 ~ 6.0910503.48 ~ 3.9020682.31 ~ 2.57401041.08 ~ 1.21601400.54 ~ 0.66801760.29 ~ 0.34
...
See also:
Compressor Components and Components Location
Components
1. Center Bolt2. Hub Bolt3. Hub Assembly4. Snap Ring5. Pulley6. Compressor Assembly
...
Room Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver.
3.
Remove the room lamp (A) after removin ...
Components and Components Location
Components
[Front Console]
1. Floor console assembly2. Front console upper complete 3. Console side cover [LH]4. Console side cover [RH]5. Console center mounting bracket6. Console rear mounti ...