>
Hyundai Equus Manuals

Hyundai Equus: Alternator Schematic Diagrams - Charging System - Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Alternator Schematic Diagrams

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Charging System / Alternator Schematic Diagrams

Circuit Diagram

   
•
COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower)
•
FR signal - The transistor activation signal inside the alternator monitors the voltage generated by the alternator to control the excitation current before it sends the FR signal to the ECM. (At certain RPM/electric loads, the FR duty can remain static. However, more often, the RPM, electric load, target voltage, etc. are always changing in the vehicle, so the FR must also change constantly)
•
L signal - Turns on the battery warning lamp on the dashboard when the battery charging system malfunctions. (Conditions for turning on the lamp - overcharge, over discharge, a field coil blown inside the alternator)
•
B+ terminal - The output voltage from the generator travels to the battery via the B+ terminal.
    Alternator Specifications
    Specification ItemSpecificationRated voltage13.5V , 180ASpeed in use1,000 ~ 18,000rpmVoltage regulatorIC Regulator built in type Regulator reform mode voltage (V) [COM terminal]13.85 ~ 14.85 (-35 ...

    Alternator Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the engine cover. 3. Remove the air cleaner assembly. (1) Remove the air duct (A). (2) D ...

    See also:

    Roof Trim Assembly Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pr ...

    Components and Components Location
    Components 1. Door module2. Window glass3. Power window motor4. Outside handle cover 5. Outside handle6. Door panel7. Door checker8. Door striker9. Outside handle pad10. Door striker cover11. Do ...

    Intake Air Temperature Sensor (IATS) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com