>
Hyundai Equus Manuals

Hyundai Equus: Alternator Repair procedures - Charging System - Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Alternator Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Charging System / Alternator Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the engine cover.
3.
Remove the air cleaner assembly.
(1)
Remove the air duct (A).
(2)
Disconnect the breather hose (B).
(3)
Loosen the clamp (C) and then disconnect the air intake hose from the throttle body.
(4)
Remove the chamber air cleaner (D) and air cleaner assembly (E).

4.
Turn the tensioner (B) clockwise and loosen, then remove the drive belt (A).

5.
Remove the oil level gauge (A).

6.
Remove the alternator.
(1)
Disconnect the alternator connector (A) and cable (B) from the ‘B’ terminal.

(2)
Loosen the alternator mounting bolts (A) and then remove alternator from the vehicle.

Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical System - "Drive Belt")
Alternator installation bolt:
26.5 ~ 33.3 Nm (2.7 ~ 3.4 kgf.m, 19.5 ~ 24.6 Ib-ft)
    Alternator Schematic Diagrams
    Circuit Diagram     • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or h ...

    Battery Description and Operation
    Description 1. The CMF(Closed Maintenance Free) battery is, as the name implies, totally maintenance free and has no removable battery cell caps. 2. The CMF(Closed Maintenance Free) batter ...

    See also:

    Sunroof Switch Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 screws holding the overhead console. Disconnect the sw ...

    Components and Components Location
    Components Location 1. Front strut assembly2. Front brake disc3. Tie rod end assembly4. Front sub frame5. Tension arm6. Lateral arm7. Front knuckle assembly ...

    Rear Variable Damper Repair procedures
    Removal 1. Remove the rear wheel & tire. Tightening torque : 90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft) 2. Disconnect the rear shock absorber (A) from the rear axle by loo ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com