>
Hyundai Equus Manuals

Hyundai Equus: Ignition Coil Repair procedures - Ignition System - Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Ignition Coil Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Ignition System / Ignition Coil Repair procedures

Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the LH/RH ignition coil connectors (A).

4.
Remove the LH/RH ignition coil (A).

   
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).

Standard value: 0.62x ± 10%
    Ignition Coil Schematic Diagrams
    Circuit Diagram ...

    Spark Plug Description and Operation
    Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture there ...

    See also:

    Opening the Fuel Filler Lid
    1. Turn the engine off. 2. Push the fuel filler lid opener button located on the driver’s door. Then the fuel filler lid slowly open (1). 3. To remove the fuel tank cap (2), turn it counterclo ...

    Trunk Lid Latch Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pr ...

    Steering Wheel Remote Controller (SWRC) Repair procedures
    Inspection 1. Check for resistance between terminals in each switch position. [LH Top (Audio)] SwitchConnectorterminalResistance(±5%)Volume Down6-7240 xSeek Down510 xMode940 xVolume Up1.69 kxSe ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com