>
Hyundai Equus: SRS components and functions

The SRS consists of the following components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side impact air bag modules
4. Curtain air bag modules
5. Retractor pre-tensioner assemblies
6. Air bag warning light
7. SRS control module (SRSCM)
8. Front impact sensors
9. Side impact sensors
10. Driver’s knee air bag module
11. “PASSENGER AIR BAG OFF” indicator (Front passenger’s seat only)
12. Occupant classification system (Front passenger’s seat only)
13. Driver’s and front passenger’s seat belt buckle sensors
14. Anchor pre-tensioner assembly
The SRSCM continually monitors all SRS components while the Engine Start/Stop Button is ON to determine if a crash impact is severe enough to require air bag deployment or pretensioner seat belt deployment.

The SRS air bag warning light "
"
on the instrument panel will illuminate for about 6 seconds after the Engine Start/Stop
Button is turned to the ON position, after which the SRS air bag warning light "
" should go out.
WARNING
If any of the following conditions occurs, this indicates a malfunction of the SRS. Have an authorized EQUUS dealer inspect the air bag system as soon as possible.

The front air bag modules are located in the center of the steering wheel, in the front passenger's panel above the glove box and in the driver’s side knee bolster. When the SRSCM detects a sufficiently severe impact to the front of the vehicle, it will automatically deploy the front air bags.

Upon deployment, tear seams molded directly into the pad covers will separate under pressure from the expansion of the air bags. Further opening of the covers then allows full inflation of the air bags.

A fully inflated air bag, in combination with a properly worn seat belt, slows the driver's or the passenger's forward motion, reducing the risk of head and chest injury.
After complete inflation, the air bag immediately starts deflating, enabling the driver to maintain forward visibility and the ability to steer or operate other controls.

WARNING
WARNING
" does not illuminate, or continuously
" to illuminate.
How does the air bag system operate
Occupant classification systemHeater & A/C Control Unit Components and Components Location
Component
Connector Pin Function
Pin No.Connector A Function1Ground2Rheostat (Illumination -)3Rear Defog Switch4-5Detent Out (+)6HTD 7Illumination + (Tail)8-9Ground10-11Climate CAN High12 ...
4&OD Clutch Control Solenoid Valve Description and Operation
Description
4&OD Clutch control solenoid valve is attached to the
valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the 4&OD Clutch. ...
Headlight, position light, turn signal light, side marker light and front fog
light bulb replacement
(1) Position light
(2) Headlight (High)
(3) Headlight (Low)
(4) Front side marker light
(5) Front turn signal light
(6) Front fog light
1. Open the hood.
2. Disconnect the negative battery ...