Hyundai Equus: Blind spot detection system (BSD) (If equipped)
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Driving your vehicle / Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
(1) BSD (Blind spot detection) The warning range depends on your vehicle speed. However, if your vehicle is about 6 mph (10 km/h) faster than the other vehicle, the system will not warn you.
(2) LCA (Lane change assist) When a vehicle approaches you at high speed, the system will warn you.
(3) RCTA (Rear cross traffic alert) When your vehicle moves rearward, the sensor detects the approaching vehicle in the left and right side, the system will warn you.
WARNING
- Always check the road condition while driving for unexpected situations even though the BSD (Blind spot detection) system is operating.
- BSD (Blind spot detection) system is a system made for convenience. Do not solely rely on the system but always pay attention to drive safely.
- Operating conditions
- Warning type
- Detecting sensor
- Warning message
- Rear cross traffic alert
- Non-operating condition
- This device complies with Part 15 of the FCC rules.
Advanced vehicle safety management (AVSM) (If equipped)
AVSM detects the distance from the vehicle ahead with the sensor, to warn you
before collision and protect you in certain hazardous situations by using warning
message, warning sound and seat belt ...
Operating conditions
The indicator on the switch will illuminate when the BSD (Blind spot detection)
system switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 9.3 mph (15 km/h), the system ...
See also:
Console Armrest Repair procedures
Replacement
[Front Console Armrest]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
prot ...
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, h ...
If engine turns over normally but does not start
1. Check fuel level.
2. With the Engine Start/Stop Button in the OFF position, check all connectors at
ignition coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the en ...
Categories
Hyundai Equus Manuals
