>

Hyundai Equus: Temperature Control Actuator Description and Operation - Heater - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Temperature Control Actuator Description and Operation

Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.
    Evaporator Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater unit lower case (A) after loos ...

    Temperature Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) ...

    See also:

    If the engine stalls at a crossroad or crossing
    If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. ...

    Repair procedures
    Inspection [System Inspection] 1. Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body. 2. Check the following points with applying ...

    8LR Brake Control Solenoid Valve Specifications
    Specifications Direct control VFS[8LR/B] x Control Type : Normal low type Control Pressure kpa (kgf/cmx, psi)0 ~ 2108.42(0 ~ 21.5, 0 ~ 305.80)Current value(mA)0~1100 Internal r ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com