>
Inspection |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or remover, remove the inside rearview mirror cover (A). |
3. |
Disconnect the connector (A) and then remove the auto defogging sensor (B). |
4. |
Install in the reverse order of removal. |
External AMP Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Open the trunk, remove the right trunk trim.
(Refer to Body - "Trunk Trim")
3.
Remove the external amplifier after disconneting ...
Hood Latch Repair procedures
Replacement
1.
Remove the hood latch cover (A) mounting clip.
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
2.
Loosen the hood latch (B) mounting bolts.
Tightening torque : ...
Rear Bumper Cover Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pro ...